|
Flowers:
1. Punch a black Stamens.
Paint the tips with Yellow Ochre. Allow to dry.
2. Place the 2 punched Daisies on the moulding pad and give “cup character”.
3. Adhere one inside the other. Off set the petals.
4. On the moulding pad, give “curving character” to the 3 leaves.
5. Place the stamens on the moulding pad, painted tips, facing downwards.
6. With “Deet”, stroke across the width of each stamen just below the round painted tip. Deet used in the horizontal position.
7. Turn the stamens over and give “cup character” to the centre including the base of each stamen.
8. With the curved tweezers, turn the painted tip outwards, facing upright.
9. Punch the ribbon hole and thread the ribbon. Option punches to use are on the left.
10. Adhere the stamens inside the Daisy. Adhere the leaves and Daisy as shown.
|
